| |
| |
Profile: |
| |
PPL112 |
| |
 |
Description: |
| |
- the transmitter is intended for mounting to the switch-board on DIN 35 rail
- it converts information from temperature sensor on range -55 až 640 °C
to the number in ASCII or MODBUS-RTU
- temperature resistor sensor can be connected by 2 or 3 wire
- baud rate can be setting from 600 up to 19200 Bd.
- suitable for using in industry enviroment |
Electrical specifications: |
| - ambient temperature: |
-25...+80°C |
| - supply voltage: |
8...28V DC (polarity reversal protection) |
| - consumption: |
typ. 2 mA, during the broadcast typ. 60 mA |
| - input signal: |
2 x Pt100, 2 x Pt1000 by IEC 751 (–55...640°C)
2 x Ni100, 2 x Ni1000 (TKR 5000 and 6180) (-40...230°C)
|
| - input connection: |
3 or 2 wire (programmable) |
| - accuracy: |
conformity error: |
< 0,03% (about 0.2°C) |
| |
temperature effect: |
< 0,05°C/10°C |
| |
linearity error: |
< 0,05% from adjust range (min: 0,1°C for 15 bit and 0,16°C for 14 bit resolurion) |
| - resolution input: |
14 or 15bit |
| - sensor current: |
< 0,6mA (mean value) |
| - output, communication: |
ASCII, MODBUS- RTU |
| - resolution on output: |
0,01°C |
| - setting response time: |
(0 - 255) ms |
| - frequence of measuring: |
see protocol |
| - digital filter |
-20 dB |
| - addressability: |
by software |
| - communication bus: |
RS485 |
| - bus termination: |
by resistor 39kW is defined rest state in all of convertors |
| - leads connection: |
terminal CUU 2,5mm2 |
| |
recommendation use shielded cable on ambient with EM disturbance |
| - protection housing / terminal: |
IP40 / IP10 |
| - mounting: |
DIN 35 mm rail |
| - dimensions: |
see schema |
| |
|
|
| Type tests: |
Basic type test:
EMC:
Safety: |
- in compliance with ČSN EN 60770-1
- in compliance with ČSN EN 61326-1
- in compliance with ČSN EN 61010-1 |
Terminal connection: |
1, 2:
3:
4, 5:
6:
7(B), 8(A):
9(-), 10(+): |
1st temperature resistive sensor (2-wire)
lead of 1st resistive sensor for 3-wire compensation
(near the sensor connect with lead nr.2)
2nd temperature resistive sensor (2-wire)
lead of 2nd resistive sensor for 3-wire compensation
(near the sensor connect with lead nr.5)
bus RS485
supply 8...28V DC |
Dimension schema: |
| |
 |
Ordering:
In an order is necessary notify:
- type of converter PPL112
- number of pieces
|
|
|
Czech version 
Polska verze 
